The subject of this final thesis is the project of the technological process.The task of this project was projecting the tecnological process according to the given annual amount and the engineering draft with the condition that products need to be produced on a daily basis. In order to fulfill the task, the analysis was performed, which consisted of analysis from constructional aspect and analysis from technological aspect. After the performed analyzes, possible forms of input material could be determined. The optimal shape was chosen due to the techno-optimal analysis. The processing allowance of the input material was determined. In the next step, the concept of the technological process was defined, which consisted of the calculation of accepted average production time per piece, determination of the number of operations and making the drafts of the operations. After that followed the selection of the machine and the clamping device which should be used for individual operations. Elaboration of operations by procedures followed, where drafts were made for every single procedure and then cutting tools, processing modes, measuring tools were chosen. When the operations by procedures were made, the production of technological documentation followed, which consisted of: list of operations, operating sheets and tools list. At the end of the implementation, the economic cutting speed for one rough operation and one for fine machining operation was calculed.